1070ti Gigabyte Tripple Fan Fanmod Installation Guide

Kit Size: 260 mm, Decal Spec: Black, RGB: No

Step 1

Using a philips head screwdriver remove the 2 screws located on the left and right handside of the card as pointed out by the red arrows.

Step 2

Remove the 2 screws on the Heatsink.

Step 3

Remove the 4 philips head bolts aswell as the two hex bolts with a pair of pliers.

Step 4

Remove the philips head screw.

Step 5

Remove the philips head screw.

Step 6

Remove the philips head screw and you should be able to remove the plastic fans and covers.

Step 7

You Have now removed the standard cooler, Time to install the Fanmod Kit :)

Step 8

Use 4 of the included flat mounting brackets to scrw into these standard locations.

Step 9

Then use the bracket and slide it though the mounting brackets untill the base of the bracket like so.

Step 10

Once you have installed the threee support brackets, line them up like the red line is showing so they are mostly alligned.

Step 11

Time to insert the fans into the main bracket. Please make sure you have the fans positioned correctly so the airflow arrow is pointing upwards towards the gpu.

Step 12

Please position the fans so that the cables are going inwards between the 2 fans as seen by the photo.

Step 13

Allign the long supports up with the main bracket and slide it in trying to evenly push either side of the support bracket.

Step 14

Once it has been slid in it should look like this.

Step 15

Please allign the back of the gpu with the kit.

Step 16

Time to insert the fans into the main bracket. Please make sure you have the fans positioned correctly so the airflow arrow is pointing upwards towards the gpu.